We provide digital infrared conversion services, do-it-yourself tutorials and custom infrared filters for photographers interested in handheld infrared photography.

- Canon Digital Rebel (300D) Infrared Conversion Instructions -

Disclaimer: This tutorial is made available for informational purposes only. Tampering with your camera will void your manufacturer's warranty. If you decide to perform the conversion you could damage your camera or be hurt or get killed from the high voltage present - you do so at your own risk, we are not responsible for camera damage or any harm you may suffer or any special or consequential damages.

Webmasters: Please do not hot link or copy content, instead you may link to this page like this: Infrared Conversion Instructions

You will need these tools & supplies to follow the Rebel infrared conversion tutorial:

- Our custom glass infrared filter to replace the hotmirror
- Soldering iron and desoldering wick or desoldering gun
- Black silicone adhesive /w syringe type dispenser
- Small philips type screwdriver
- Tweezers
- Canned air
- Lens cleaning solution & tissue
- Grounding strap /w current limit resistor

If you prefer not to risk damage to your camera, have us convert it for you here. It would be best to perform the conversion in a well lit area that is as clean and dust free as possible. Wearing a grounding strap will minimize the chance of zapping your camera with static and most likely rendering it dead.

Remove the rubber eye cup.

Remove the self adhesive screw cover.

Remove marked screws.

Remove marked screws.

Remove marked screws.

Remove the I/O covers.

Lift up the rear LCD panel and disconnect the marked ribbon cable.

Remove marked screws.

Desolder marked solder joint.

Flip over the rear LCD assembly and disconnect marked cables.

Desolder marked solder joints.

Lift out the metal noise sheild.

Disconnect marked cables.

Remove marked screws and I/O mount (blue arrow).

Flip over the PCB and disconnect marked cables.

Remove marked screws and lift out the sensor assembly.

Peel off the black plastic mask.

Remove marked screws.

Pry up the hot mirror assembly which is affixed with double stick black tape.

Remove the black double stick tape.

Cut the adhesive around the hot mirror filrer.

Replace with the infrared filter and seal with black silicone.

Remove the marked focus spacers.

After adhesive is fully cured clean the ir filter with lens cleaner and tissue, blow off with canned air and reassemble everything by following the instructions backwards. Set a custom white balance per our instructions page and take some test shots to make sure there is no dust trapped between the sensor and infrared filter. If you find dust and find it objectionable disassemble the camera again, blow off the sensor with canned air (make sure only air and no liquid is coming out by purging and holding it upright) and re cleaning the infrared filter.

If you prefer not to risk damage to your camera, have us convert it for you here.

Home | Digital Infrared FAQ | How To Instructions | Sample IR Images | Tutorials | Order Now | Contact Us